| | 4 | |
| | 5 | == September 29 (Haydn) == |
| | 6 | - ipp080 - fixed the SSD problem, but discovered only 128GB RAM is showing instead of 192GB. Also, one fan isn't working due to a bad connector. Machine is partially setup, but won't boot from the SSD's. |
| | 7 | - ipp073 - noticed a fan wasn't spinning. |
| | 8 | - enabled all of the users on cab17con, and removed the obsolete users on the other serial consoles. |
| | 9 | - cab17con - configured the power control to work. |
| | 10 | - tested and discarded a used PDU -- none of the outlets would turn on. |
| | 11 | |
| | 12 | == September 25 (Haydn) == |
| | 13 | - cab16 - swapped another PDU in for the one which wasn't working. |
| | 14 | |
| | 15 | == September 23 (Haydn) == |
| | 16 | - Found the solution to the serial console problem. |
| | 17 | - ipp078 - setup. |
| | 18 | - ipp076, ipp078, ipp079, ipp081 - released. |
| | 19 | |
| | 20 | == September 22 (Haydn) == |
| | 21 | - ipp013 - replaced drive #10, because it had two separate errors on Fri. |
| | 22 | - ipp013 - a few minutes later it rebooted itself and gave a CMOS checksum error. Replaced the CMOS battery. |
| | 23 | - cab17con - removed the ACS16 and replaced it with the ACS48. Configured the ACS48. |
| | 24 | - installed the new Cisco 40 port 10GE switch. Not sure how to turn it on. |
