Changes between Version 14 and Version 15 of MD01.refstack.20130731

Timestamp:

Aug 12, 2013, 10:49:14 AM (13 years ago)

Author:

Mark Huber

Comment:

--

MD01.refstack.20130731

@@ -1 @@
-= Summary of MD01.refstack.20130731 (incomplete) =
+= Summary of MD01.refstack.20130731 =
 [[PageOutline]]
 
@@ -143 +143 @@
   * y: s012,013 and others with bright edges; s014 odd underflux print through; s024,025,026,036,047 poor cell bands (need to be masked in y); s066,076,077 super ghost..; s087 extra over rejection?
   * z: s012,013 again bright edge but almost really good; s021 extra over rejection?; s075 odd junk; s087 same; super ghost same
-  * i: s012,013  again bright chunk edges; s016 underflux print through; s047 underflux by bright; s071 large psf; super ghost; s087 extra over rejection?
+  * i: s012,013  again bright chunk edges; s016 underflux print through; s047 underflux by bright source; s071 large psf; super ghost; s087 extra over rejection?
   * r: s012,013 etc again; s015,025,026,041,051,061, ghosts ; s027 under flux bands (seen in others too); s047 underflux area and other junk/cells; s087 extra over rej? or high sky?
   * g: s013 bright chunk edges (not really s012 from over rej?); s013,015,023,024,025,026,027,034,041,042,043!! ghosts s047,061 junk; s016 under flux chunks/strips; s054 odd cell print through; s044,054 poor cell arc/scatter (wonder if could/should mask cell as seen in [wiki:MD01.refstack.20120803])
  * some convolved stacks have poorer FWHM PSF but not significant enough to be likely improved by reprocessing using MD_DEEP_STACK config as in earlier MD fields (input cut <10 rather than <6 and FWHM+100*STDEV rather than FWHM+1.0*STDEV)
-  *  
-
+  * g: s071g -- -- no real improvement found since edge skycell and kept original 
+  * g: s082 -- very few inputs (4) 30/34 rej --  edge skycell and g-band so most are cut >6, MD_DEEP_STACK config has 4/19 rej 
+  * i: s071 -- very few inputs (4), 27/31 rej and bad target PSF (conv image will be mostly useless) -- use MD_DEEP_STACK and 1/12 rej with slightly better target PSF (but still poor) 
+  * y: s016 -- quality fault with PSF problem -- reduced elong cut 1.3->1.25 and increased FWHM input cut from 3.8->3.9 pixels, still used MD_REF_STACK reduction config
+  * re-processing tests (have not written this up before and should note):
+   * data_group -- MD01.refstack.20130731redo
+   * workdir base -- MD01.refstack.20130731redo
+  * unused redo processing
+   * label -- MD01.refstack.20130731skip
+   * data_group -- MD01.refstack.20130731redo
+   * workdir base -- MD01.refstack.20130731redo
+  * replaced original run
+   * label -- MD01.refstack.20130731poor 
+   * data_group -- MD01.refstack.20130731poor 
+   * workdir base -- original name MD01.refstack.20130731
+  * redo processing replacing original processing
+   * label -- normal refstack label
+   * data_group -- normal refstack data_group
+   * workdir base -- MD01.refstack.20130731redo